When decorating a house, we all use a lot of auxiliary materials. For example, tile adhesive is the most common one. Although most people are curious about what it is, they don’t have a specific understanding. So, Zhongtaojun Let’s get started today, let’s learn about how to use tile adhesive together!
1. What is tile adhesive
Tile adhesive, also known as ceramic tile adhesive or adhesive, viscose mud and other names, is a new material for modern decoration, replacing traditional cement yellow sand. The adhesive force is several times that of cement mortar. It can effectively paste large ceramic tiles and stones to avoid the risk of bricks falling off. Good flexibility to prevent hollowing during production. Mainly used for pasting ceramic tiles, tiles, floor tiles and other decorative materials, widely used in interior and exterior walls, floors, bathrooms, kitchens and other building decoration places.
2. How much tile adhesive is needed for 100 square meters? Is it expensive?
This is directly related to the quality and size of the tiles. If the ceramic tile is smaller than 300*300, it is recommended to use a 6*6MM toothed scraper, and the amount per square meter is about 100%. If the ceramic tile is larger than 300*300, then a 10*10MM toothed scraper is needed to meet the bonding requirements, and the dosage per square meter is about 5KG. Generally speaking, the price is still within everyone's acceptable range. If the area is larger, the price will be relatively more expensive. However, the more you buy, the price will be a little bit cheaper!
3. How to use tile adhesive
Before construction, we need to prepare the required materials to ensure that the construction proceeds smoothly and efficiently. The specific tools are as follows: tile glue, electric mixer, spatula, toothed scraper, sturdy plastic bucket, level, plastic cross, glue hammer, etc.
1. Base surface cleaning
When the tools are ready, we need to clean the base surface. The requirement for the base surface is that it should be smooth and solid, without sand, cracks, scratches, uneven unevenness, and dust, stains, etc. If the base surface is uneven and has stains, it is recommended that you use Knorrbond interface agent, putty powder, etc. to apply glue (loose base surface), roughen (smooth base surface) or level it.
2. Add water and stir evenly
After the base surface is cleaned, we need to mix it with clean water according to the sameMix in a certain proportion. The order of addition is: liquid first and then powder. The specific ratio is: 20kg: tile glue and water. Then we use an electric mixer to stir evenly until it becomes a paste without particles, and then let it sit for 10 minutes until it is fully matured, then stir it again and then it can be used normally. For the evenly stirred slurry, it is recommended that you use it within 2-3 hours.
3. Large-area construction
After it is mixed evenly, we need to spray the base surface with water. It must be completely wet but there should be no open water. After that, we use a toothed scraper to evenly apply the tile adhesive on the wall and the back of the tiles. During the scraping process, we must ensure that the angle of the toothed scraper and the base surface is consistent. Apply about 1-2 square meters each time, and then start from the bottom Just knead and press the tiles on, and then make fine adjustments within 15 minutes.
The above is what Zhongtaojun shared with you about Tile Adhesive. Generally speaking, the usage method is relatively simple and easy to understand. If you are renovating your home, you might as well try it yourself. , if the effect is not good, you can also ask a professional decorator to do it. Well, that’s it for today’s content sharing, Zhongtao Jun will leave first! ! !
